For makers and small studios
3D printed moulds for casting
Moulds, mould boxes and master patterns for resin, plaster, concrete, wax and soap. Upload your model, see the price, and if you order before 1pm on a weekday a small part can be posted the same day. On Saturdays the part must finish printing by 12 noon, so order by about 11am for a one-hour part.
- Largest single piece
- 250 mm
- Filaments
- PLA, PETG, ASA
- Same-day cut-off, Mon–Fri
- 1pm
Three ways to use a print
Cast straight into the print
A rigid printed mould for plaster, concrete, jesmonite and many resins. Use a mould release agent, and design it to come apart or to be broken off.
Master pattern for silicone
Print the shape, then pour silicone around it to make a flexible mould you can cast from again and again. The print sets the detail.
Mould boxes and frames
Walls, keys and pour spouts that hold the silicone while it cures, sized to your pattern so you waste less rubber.
Heat decides the filament
PLA softens at about 55 °C, PETG at about 70 °C and ASA at about 90 °C. That is fine for silicone, plaster and most slow-curing resins, but hot wax, melt-and-pour soap and large resin pours that warm up as they cure can pass those figures. For anything warm, choose PETG or ASA and test with a small pour first. The materials page has the full comparison.
Surface finish
A cast copies everything, including the print's fine layer lines. For a smooth face choose Finished, from £8, and we sand the mould surface; or seal it yourself with a clear coat before the first pour. Some silicones do not cure properly against certain filaments and coatings, so try the combination on an offcut first.
Not for food
Printed parts are not food-safe, so we do not print moulds for chocolate, ice, sweets or anything else people eat.
Bigger moulds and two-part moulds
One piece can be up to about 250 × 250 × 250 mm. Larger moulds can be printed in sections that key together. If you have the shape but not the mould design, describe the part and we will tell you whether we can design the mould, and what it would cost.
Upload a model and see the price before you pay.