3DNow

For makers, engineers and workshops

Custom 3D printed enclosures and housings

Cases, enclosures and containers made to fit exactly what goes inside: a circuit board, a sensor, a set of tools or a drawer full of parts. Upload your model, see the price, and if you order before 1pm on a weekday it is posted the same day. On Saturdays the part must finish printing by 12 noon, so order by about 11am for a one-hour part.

Largest single piece
250 mm
Filaments
PLA, PETG, ASA
Same-day cut-off, Mon–Fri
1pm

What people print

Electronics enclosures

A case made to your board, with openings for connectors, buttons, displays and vents, and posts or clips to hold it. A snap-fit or screwed lid keeps it serviceable.

Mounts and brackets

Wall plates, DIN-style clips, camera and sensor mounts and cable guides, sized to the thing you are fixing and the place it goes.

Storage and organisers

Trays, inserts and boxes cut to your drawer, toolbox or case, with a pocket for each item so everything has one place.

Protective cases

Cases for instruments, meters, remotes and one-off gadgets, with the thickness and lid style you choose.

Made to your measurements

If you have a model, upload it. If you have only the board or the item, describe the part with its dimensions and a photo and we will tell you whether we can design the housing, and what it would cost. A board's published mechanical drawing makes the fit much more reliable.

Which filament

PLA is stiff and prints crisply: fine for indoor cases that stay cool. PETG is tougher and takes knocks and the odd drop. ASA holds up in sun and heat, so choose it for outdoor boxes and for cases that sit near warm electronics. The materials page compares them.

Heat, water and mains power

Printed parts are not flame-retardant, and a case with vents is not waterproof. Do not use a printed case as the enclosure for mains-voltage wiring unless your design and the regulations allow it. For an electronics project that gets warm, leave room for airflow and pick PETG or ASA. A sealed outdoor box needs a gasket and a sensible lid design, and we cannot certify one as watertight.

Fit and finish

Printed holes come out slightly small and parts can shrink a little as they cool, so allow a fraction of a millimetre of clearance for boards and lids. One piece can be up to about 250 × 250 × 250 mm; larger boxes print in sections that join together. For a smoother, sanded face choose Finished, from £8.

Get a price

Upload a model and see the price before you pay.