3DNow

For repairs and spares

3D printed replacement parts

A knob has snapped, a clip has gone missing or a bracket has cracked, and the maker no longer sells the part. Upload a model, or describe what you need, and we print it and post it, often the same day if you order before 1pm on a weekday. On Saturdays the part must finish printing by 12 noon, so order by about 11am for a one-hour part.

Largest single piece
250 mm
Filaments
PLA, PETG, ASA
Same-day cut-off, Mon–Fri
1pm

What gets replaced

Knobs, handles and caps

Cooker and appliance knobs, drawer and cupboard handles, radiator and valve caps, battery covers and lids.

Clips, catches and brackets

Trim clips, shelf supports, hinges, latches, curtain and blind fittings, and mounts that have cracked or snapped.

Gears, spacers and bushes

Small mechanical parts for tools, toys and household machines, from a model or a copy of the worn original.

Covers, feet and fittings

Vent covers, foot pads, spool holders, hose adaptors and enclosures for things that no longer have spares.

No model of the part?

Most broken parts do not come with a file. Describe the part with a photo of it, its measurements and what it is for, and we tell you whether we can design it and what it would cost. A part a person designs has a £10 design charge per part, and you see the full price before anything is made. Our AI design assistant has no design fee. Include the make and model of the thing it fits, and a ruler or callipers reading for the dimensions that matter, such as hole spacing and thickness. Parts we have already designed for customers who agreed to share them are on the parts page, ready to order with no design charge.

Measuring a part

Measure twice and note which sizes are critical: the hole centres, the diameter it fits over, the thickness of anything it slides into. Keep the broken pieces, since they show the original shape. Printed holes come out slightly small, so put the size you need in your description.

Which filament

PETG is the safe choice for most functional repairs: tough, a little flexible and good in damp places. PLA is stiffer and crisper but softens from about 55 °C and can snap. ASA suits anything outside or hot, such as car, garden and shed parts. The materials page compares them.

Where a printed part is not right

Do not use a printed part where its failure could hurt someone: brakes, steering, load-bearing and lifting parts, gas, pressure and mains-voltage fittings, child seats and safety equipment. Printed parts are not food-safe and not flame-retardant. Layer lines make a printed part weaker between layers than along them.

Price

The price is shown before you pay. There is a minimum order of £4 and a small setup charge. A part printed in a single piece can be up to about 250 × 250 × 250 mm.

Get a price

Upload a model and see the price before you pay.